DTC B1579 Voice Recognition Microphone Disconnected |
| DTC Code | DTC Detection Condition | Trouble Area |
| B1579 | Telephone microphone signal is lost. |
|

| 1.CHECK MICROPHONE (OPERATION CHECK) |
Enter the "Microphone & Voice Recognition Check" screen (Click here).
![]() |
When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER - MAP LIGHT) |
Disconnect the R21 radio and display receiver assembly connector.
Disconnect the M3 map light assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R21-4 (MACC) - M3-4 (MACC) | Always | Below 1 Ω |
| R21-5 (MIN+) - M3-3 (MCO+) | ||
| R21-19 (MIN-) - M3-2 (MCO-) | ||
| R21-6 (SNS2) - Body ground | ||
| R21-4 (MACC) - Body ground | Always | 10 kΩ or higher |
| R21-5 (MIN+) - Body ground | ||
| R21-19 (MIN-) - Body ground | ||
| R21-18 (SGND) - Body ground |
|
| ||||
| OK | |
| 3.CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R21-18 (SGND) - Body ground | Always | Below 1 Ω |
| R21-19 (MIN-) - Body ground |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| R21-4 (MACC) - Body ground | Ignition switch ACC | 4 to 6 V |
| *a | Component with harness connected (Radio and Display Receiver Assembly) |
|
| ||||
| OK | |
| 4.REPLACE TELEPHONE MICROPHONE WITH ANOTHER AND CHECK |
Replace the telephone microphone with a normal one (Click here).
Check if the same problem occurs again.
|
| ||||
| OK | ||
| ||