Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Parking Brake Switch Circuit


DESCRIPTION

This circuit includes the parking brake switch and navigation receiver assembly.

WIRING DIAGRAM


C240177E11


INSPECTION PROCEDURE

1.CHECK PARKING BRAKE SWITCH ASSEMBLY


    E234527E04
  1. Display the "Connection Status" screen (Click here).

  1. Check that the display changes between On and Off according to the parking brake operation.

    OK:
    Parking Brake Condition
    Display
    Applied
    On
    Released
    Off

    HINT:
    This display is updated once per second. As a result, it is normal for the display to lag behind the actual parking brake operation.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - PARKING BRAKE SWITCH ASSEMBLY)
  1. Disconnect the N6 navigation receiver assembly connector.

  1. Disconnect the P3 parking brake switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    N6-6 (PKB) - P3-1
    Always
    Below 1 Ω
    N6-6 (PKB) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT PARKING BRAKE SWITCH ASSEMBLY


    C217121
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    Switch connector terminal - Switch body
    On (Shaft not pressed)
    Below 1 Ω
    Off (Shaft pressed)
    10 kΩ or higher

    Text in Illustration 
    V100135
    On
    V100136
    Off
    If the result is not as specified, replace the parking brake switch assembly.



NG
REPLACE PARKING BRAKE SWITCH ASSEMBLY (Click here)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)