BACK DOOR > DISASSEMBLY |
| 1. REMOVE DOOR PULL HANDLE |
![]() |
Detach the 4 claws and remove the door pull handle.
| 2. REMOVE BACK DOOR TRIM BOARD ASSEMBLY |
![]() |
Detach the 16 clips and remove the back door trim board.
| 3. REMOVE BACK DOOR LOCK ASSEMBLY |
Disconnect the connector and detach the clamp.
Disconnect the back door lock cable.

| *1 | Back Door Lock Cable Assembly | - | - |
![]() |
Remove the 3 bolts and back door lock.
| 4. REMOVE BACK DOOR OUTSIDE HANDLE |
![]() |
Remove the 2 nuts and back door outside handle.
| 5. REMOVE REAR TELEVISION CAMERA ASSEMBLY (w/ Rear View Monitor System) |
![]() |
Disconnect the connector.
Remove the 2 nuts and rear television camera assembly.
| 6. REMOVE BACK DOOR OUTSIDE GARNISH |
![]() |
w/ Rear View Monitor System:
Remove the nut.
![]() |
w/o Rear View Monitor System:
Remove the 3 nuts.
![]() |
Put protective tape around the back door outside garnish.
| *1 | Protective Tape |
Detach the 2 clips and remove the back door outside garnish.
| 7. REMOVE REAR LIGHT ASSEMBLY LH |
![]() |
Disconnect the connector.
Remove the 2 nuts.
![]() |
Put protective tape around the rear light assembly LH.
| *1 | Protective tape |
Detach the clip and pin as shown in the illustration.
Remove the rear light assembly LH.
| 8. REMOVE REAR LIGHT ASSEMBLY RH |
| 9. REMOVE REAR WIPER ARM AND BLADE ASSEMBLY |
![]() |
Open the wiper arm head cap.
![]() |
Remove the nut and arm and blade.
| 10. REMOVE REAR WIPER MOTOR ASSEMBLY |
![]() |
Disconnect the connector.
Remove the 3 bolts and wiper motor.
| 11. REMOVE REAR WIPER MOTOR GROMMET |
![]() |
Remove the rear wiper motor grommet.
| 12. REMOVE NO. 2 BACK DOOR SERVICE HOLE COVER |
![]() |
Detach the 4 claws.
![]() |
Disconnect the connector.
Detach the clamp and remove the No. 2 back door service hole cover.
| 13. REMOVE REAR SPOILER |
![]() |
Remove the 2 grommets.
![]() |
Remove the 3 nuts.
![]() |
Put protective tape around the rear spoiler.
| *1 | Protective Tape |
Detach the 4 clips and remove the rear spoiler.
| 14. REMOVE REAR WASHER NOZZLE SUB-ASSEMBLY |
![]() |
Disconnect the washer hose.
Detach the 2 claws and remove the rear washer nozzle.
| 15. REMOVE BACK DOOR GLASS CHANNEL LH |
![]() |
Using a clip remover, remove the 2 clips.
Using a screwdriver, detach the tape and remove the channel.
| 16. REMOVE BACK DOOR GLASS CHANNEL RH |
| 17. REMOVE BACK DOOR PANEL CUSHION |
![]() |
Remove the 2 back door panel cushions.
| *1 | for Upper Side |
| *2 | for Lower Side |
| 18. REMOVE BACK DOOR LOWER STOPPER |
![]() |
Remove the bolt and back door lower stopper.
| 19. REMOVE BACK DOOR STAY ASSEMBLY LH |
![]() |
Remove the 4 bolts and back door stay.
| 20. REMOVE BACK DOOR STAY ASSEMBLY RH |