Home › BODY › EXTERIOR › REAR DOOR GLASS WEATHERSTRIP

REAR DOOR GLASS WEATHERSTRIP > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL


    B277098
  1. Using a moulding remover, detach the 2 clips and 2 claws.

  1. Disconnect the connector and remove the rear power window regulator switch assembly with rear door armrest base panel.



2. REMOVE DOOR PULL HANDLE


    B277099
  1. Remove the screw and door pull handle.



3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    B279384
  1. Remove the screw.

  1. Detach the 10 clips and remove the rear door trim board.



4. REMOVE REAR DOOR OUTER GLASS WEATHERSTRIP LH


    B279385E01
  1. Put protective tape around the rear door outer glass weatherstrip.
    Text in Illustration 
    *1
    Protective Tape

  1. Detach the 4 claws and remove the rear door outer glass weatherstrip.