Home › BODY › EXTERIOR › SIDE MOULDING (for Rear Door)

SIDE MOULDING (for Rear Door) > REASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. INSTALL REAR DOOR NO. 1 MOULDING PAD

HINT:
When installing the rear door No. 1 moulding pad, heat the rear door outside moulding using a heat light.

Standard:
Item
Temperature
Rear Door Outside Moulding
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the rear door outside moulding excessively.

  1. Clean the rear door outside moulding surface.

    1. Using a heat light, heat the rear door outside moulding surface.

    2. Remove the double-sided tape from the rear door outside moulding.

    3. Wipe off any tape adhesive residue with cleaner.



    B277907
  1. Install a new rear door No. 1 moulding pad.

    1. Remove the peeling paper from the face of a new rear door No. 1 moulding pad.

      HINT:
      After removing the peeling paper, keep the exposed adhesive free from foreign matter.

    2. Install the rear door No. 1 moulding pad.