SIDE MOULDING (for Rear Door) > REMOVAL |
| 1. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL |
![]() |
Using a moulding remover, detach the 2 clips and 2 claws.
Disconnect the connector and remove the rear power window regulator switch assembly with rear door armrest base panel.
| 2. REMOVE DOOR PULL HANDLE |
![]() |
Remove the screw and door pull handle.
| 3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH |
![]() |
Remove the screw.
Detach the 10 clips and remove the rear door trim board.
| 4. REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY LH |
![]() |
Detach the claw and 2 guides as indicated by the arrows in the order shown in the illustration.
![]() |
Disconnect the rear door inside locking cable and rear door lock remote control cable and remove the rear door inside handle.
| 5. REMOVE REAR DOOR NO. 2 TRIM BRACKET |
![]() |
Remove the screw.
Detach the 10 clips and remove the rear door trim board.
| 6. REMOVE REAR DOOR SERVICE HOLE COVER LH |
![]() |
Pull out the rear door inside locking cable, rear door lock remote control cable and wire harness from the rear door service hole cover, and then remove the rear door service hole cover.
| 7. REMOVE REAR DOOR OUTSIDE MOULDING LH |
Put a 4 mm (0.157 in.) drill bit into a drill.
![]() |
Wind tape around the drill bit approximately 5 mm (0.197 in.) from the tip of the drill as shown in the illustration.
| Area | Specified Condition |
| A | 5 mm (0.197 in.) |
Lightly press the drill against the 3 rivets and drill off the flanges of the 3 rivets.
![]() |
Put protective tape around the rear door outside moulding.
| *1 | Protective Tape |
Detach the 5 clips and remove the rear door outside moulding.
Remove the 5 clips from the vehicle body.
Using a vacuum cleaner, remove the rivet fragments and shavings from the drilled area.