Home › BODY › EXTERIOR › SIDE MOULDING (for Rear Side)

SIDE MOULDING (for Rear Side) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE REAR QUARTER PANEL MUDGUARD LH
  1. Install the rear quarter panel mudguard with the 6 screws.



2. REMOVE REAR QUARTER PANEL MUDGUARD RH

HINT:
Use the same procedure described for the LH side.



3. REMOVE REAR BUMPER COVER


    B277918
  1. Remove the 3 clips.



    B277919
  1. Remove the 2 clips and 6 screws.



    B277920E01
  1. Put protective tape around the rear bumper cover.
    Text in Illustration 
    *1
    Protective Tape

  1. w/ TOYOTA Parking Assist-sensor System:
    Disconnect the 2 No. 3 luggage room wire connectors.

  1. Detach the 8 claws and remove the rear bumper cover.



4. REMOVE REAR NO. 1 WHEEL OPENING EXTENSION LH


    B277905E01
  1. Put protective tape around the rear No. 1 wheel opening extension.
    Text in Illustration 
    *1
    Protective Tape

  1. Remove the 2 screws.

  1. Detach the 6 clips and remove the rear No. 1 wheel opening extension.

  1. Remove the 6 clips from the vehicle body.



5. REMOVE SIDE STEP ASSEMBLY LH (w/ Side Step)


    B277855
  1. Remove the 5 bolts, nut and side step.



6. REMOVE REAR NO. 2 WHEEL OPENING EXTENSION LH


    B277904E01
  1. Put protective tape around the rear No. 2 wheel opening extension.
    Text in Illustration 
    *1
    Protective Tape

  1. Remove the retainer.

  1. Detach the 2 clips and remove the rear No. 2 wheel opening extension.

  1. Remove the 2 clips from the vehicle body.