Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

DTC    B15C2    Speed Signal Malfunction


DESCRIPTION

The navigation receiver assembly receives a vehicle speed signal from the combination meter assembly and information about the navigation antenna, and then adjusts the vehicle position.
The navigation receiver assembly stores this DTC when the difference between the speed information that the navigation antenna receives and the SPD pulse received from the combination meter assembly becomes large.

HINT:
  1. A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter assembly. The signal is changed to a pulse signal at the transistor in the combination meter assembly. Each ECU controls the respective systems based on the pulse signal.
  2. If a short occurs in any of the ECUs or in the wire harness connected to an ECU, all systems in the diagram below will not operate normally.


DTC Code
DTC Detection Condition
Trouble Area
B15C2
A difference between the GPS speed and SPD pulse is detected.
  1. Harness or connector
  2. Combination meter assembly
  3. Navigation receiver assembly

WIRING DIAGRAM


E238676E02


INSPECTION PROCEDURE

1.CHECK VEHICLE SENSOR (OPERATION CHECK)


    E234527E02
  1. Display the "Connection Status" screen (Click here).

  1. While driving the vehicle, check that the value and gauge change in response to changes in vehicle speed.

    OK:
    The value and gauge change in response to changes in vehicle speed.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - COMBINATION METER ASSEMBLY)
  1. Disconnect the N5 navigation receiver assembly connector.

  1. Disconnect the C26 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    N5-17 (SPD) - C26-6
    Always
    Below 1 Ω
    N5-17 (SPD) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK COMBINATION METER ASSEMBLY


    E190309E19
  1. Remove the combination meter assembly with the connector(s) still connected.

  1. Connect an oscilloscope to terminal C26-6 and body ground.

  1. Check the signal waveform according to the condition(s) in the table below.
    Measurement Condition 
    Item
    Condition
    Terminal No. (Symbol)
    C26-6 - Body ground
    Tool setting
    5 V/DIV., 20 ms./DIV.
    Condition
    Vehicle being driven at approximately 20 km/h (12mph)

    OK:
    The waveform display is as shown in the illustration

    HINT:
    When the system is function normally, one wheel revolution generates 4 pules.
    As the vehicle speed increases, the width indicated by (A) in the illustration narrows.

    Text in Illustration 
    *a
    Component with harness connected
    (Combination Meter Assembly)



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)