REAR AIRBAG SENSOR > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE REAR SEAT ASSEMBLY |
Remove the rear seat assembly (Click here).
| 3. REMOVE REAR DOOR SCUFF PLATE LH |
![]() |
Put protective tape around the rear door scuff plate.
| *1 | Protective Tape |
Using a moulding remover, detach the 7 claws and 2 clips and remove the rear door scuff plate.
| 4. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH |
![]() |
Remove the rear door opening trim weatherstrip.
| 5. REMOVE BACK DOOR SCUFF PLATE |
![]() |
Detach the 4 claws, 2 guides and 6 clips and remove the back door scuff plate.
| 6. REMOVE QUARTER INSIDE TRIM BOARD LH |
![]() |
Detach the 2 claws and remove the outer lap belt anchor cover.
![]() |
Remove the bolt and disconnect the rear No. 1 seat outer belt floor anchor.
![]() |
w/ Rear No. 2 Seat:
Remove the bolt and disconnect the rear No. 2 seat outer belt floor anchor.
Using a clip remover, remove the clip.
Detach the 7 claws and 10 clips.
Disconnect the power point socket connector and remove the quarter inside trim board.

| 7. REMOVE REAR AIRBAG SENSOR LH |
![]() |
Remove the bolt and rear airbag sensor.
Disconnect the connector.