AUDIO AND VISUAL SYSTEM (for Radio and Display Type) > Display Signal Circuit between Radio Receiver and Stereo Jack Adapter |

| 1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
Disconnect the R21 radio and display receiver assembly connector.
Disconnect the N13 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R21-13 (VV+) - N13-6 (VV+) | Always | Below 1 Ω |
| R21-14 (VV-) - N13-11 (VV-) | ||
| R21-13 (VV+) - Body ground | Always | 10 kΩ or higher |
| R21-14 (VV-) - Body ground | ||
| R21-12 (SG) - Body ground |
|
| ||||
| OK | ||
| ||