Home › BRAKE › BRAKE › BRAKE BOOSTER (for TMMIN Made)

BRAKE BOOSTER (for TMMIN Made) > REMOVAL

for Preparation Click here



1. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.



2. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
(Click here)


3. REMOVE BRAKE BOOSTER ASSEMBLY
  1. for 1KD-FTV:
    Disconnect the vacuum warning switch connector and remove the vacuum warning switch from the booster.

  1. Disconnect the vacuum hose.

  1. Remove the check valve and grommet from the brake booster.



    C226773E01
  1. Remove the return spring, clip and clevis pin.



    C111300
  1. Remove the 4 nuts and push rod clevis.

  1. Pull out the booster and gasket.