Home › BRAKE › BRAKE › FRONT BRAKE (for TMMIN Made)

FRONT BRAKE (for TMMIN Made) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE FRONT WHEEL


2. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.



3. REMOVE FRONT DISC BRAKE ANTI-RATTLE SPRING


  1. for 15 inch Front Disc Brake:



      C215909E01
    1. Remove the pin hold clip and 2 disc brake pad guide pins.

    2. Remove the anti-rattle spring.

      NOTICE:
      The anti-rattle spring can be reused if has sufficient rebound; no deformation, cracks or wear; and has all rust, dirt and foreign matter cleaned off.



  1. for 16 inch Front Disc Brake:



      F043185E05
    1. Remove the 2 pin hold clips and 2 disc brake pad guide pins.

    2. Remove the anti-rattle spring.

      NOTICE:
      The anti-rattle spring can be reused if it has sufficient rebound; no deformation, cracks or wear; and has all rust, dirt and foreign matter cleaned off.



4. REMOVE FRONT DISC BRAKE PAD
  1. Remove the 2 front disc brake pads from the disc brake cylinder.



5. REMOVE FRONT ANTI-SQUEAL SHIM KIT
  1. Remove the the 2 No. 1 anti-squeal shims and 2 No. 2 anti-squeal shims from each pad.



6. DISCONNECT FRONT NO. 1 WHEEL CYLINDER TUBE LH


    F043120
  1. Using a union nut wrench, disconnect the tube from the cylinder.



7. REMOVE DISC BRAKE CYLINDER ASSEMBLY LH


    C111377
  1. Remove the 2 bolts and cylinder.



8. REMOVE FRONT DISC


    C111383E01
  1. Put matchmarks on the disc brake and axle hub.

  1. Remove the disc.