Home › BRAKE › BRAKE › FRONT BRAKE (for TMMIN Made)

FRONT BRAKE (for TMMIN Made) > DISASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE CYLINDER BOOT


    C111378E01
  1. Using a screwdriver, remove the 4 set rings and 4 cylinder boots from the disc brake cylinder.

    HINT:
    Tape the screwdriver tip before use.

    NOTICE:
    Be careful not to damage the brake piston and disc brake cylinder.



2. REMOVE FRONT DISC BRAKE PISTON


    C111364E02
  1. Prepare a wooden plate to hold the pistons.

  1. Place the wooden plate between the pistons and insert a pad on one side.



    F042677
  1. Use compressed air remove the pistons alternately from the cylinder.

    CAUTION:
    Do not place your finger in front of the piston when using compressed air.

    NOTICE:
    Be careful not to spatter the brake fluid.



3. REMOVE PISTON SEAL


    F042678E01
  1. Using a screwdriver, remove the 4 piston seals from the cylinder.

    HINT:
    Tape the screwdriver tip before use.

    NOTICE:
    Be careful not to damage the inner cylinder and cylinder groove.



4. REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP


5. REMOVE FRONT DISC BRAKE BLEEDER PLUG