Home › BRAKE › BRAKE › FRONT BRAKE (for TMMIN Made)

FRONT BRAKE (for TMMIN Made) > REASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. TEMPORARILY TIGHTEN FRONT DISC BRAKE BLEEDER PLUG
  1. Temporarily install the bleeder plug to the cylinder.

    HINT:
    The bleeder plug will be tightened to a torque specification in the Bleed Brake Line procedures.

  1. Install the cap to the bleeder plug.



2. INSTALL PISTON SEAL
  1. Apply a light coat of lithium soap base glycol grease to 4 new piston seals.

  1. Install the 4 piston seals to the disc brake cylinder.



3. INSTALL FRONT DISC BRAKE PISTON


    C236942E02
  1. Apply lithium soap base glycol grease to the 4 pistons and 4 new cylinder boots.

  1. Install the 4 boots to the pistons.

  1. Install the 4 pistons (with the boots) to the cylinder.

    NOTICE:
    Do not forcibly install the pistons to the cylinder.



4. INSTALL CYLINDER BOOT


    C236943
  1. Install the 4 boots to the cylinder.

  1. Using a screwdriver, install the 4 set rings.

    NOTICE:
    Be careful not to damage the boot.