Home › BRAKE › BRAKE › REAR BRAKE (for TMMIN Made)

REAR BRAKE (for TMMIN Made) > INSPECTION

for Preparation Click here



1. CHECK BRAKE DRUM INSIDE DIAMETER


    C111395
  1. Using a drum gauge or equivalent, measure the inside diameter of the drum.

    Standard inside diameter:
    295.0 mm (11.614 in.)

    Maximum inside diameter:
    297.0 mm (11.693 in.)

    If the inside diameter of the drum is greater than the maximum, replace the drum.



2. CHECK BRAKE SHOE LINING THICKNESS


    C111504
  1. Using a ruler, measure the thickness of the shoe lining.

    Standard thickness:
    5.4 mm (0.213 in.)

    Minimum thickness:
    1.0 mm (0.0394 in.)

    If the lining thickness is less then the minimum value, or if any severe or uneven wear, replace the brake shoe.

    NOTICE:
    If the brake shoes need to be replaced, the must be replaced as a set.



3. CHECK BRAKE DRUM AND BRAKE SHOE LINING PROPER CONTACT


    C111484
  1. Apply chalk to the inside surface of the drum, and then grind the brake shoe lining so that it fits together with the drum properly.
    If the contact between the drum and the shoe lining is improper, make adjustments using a brake shoe grinder of replace the brake shoe assembly.



4. CHECK REAR WHEEL BRAKE CYLINDER ASSEMBLY
  1. Check the cylinder bore and piston for rust and scoring.