Home
›
DRIVE LINE
›
DIFFERENTIAL
›
FRONT DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL
FRONT DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL > REPLACEMENT > Preparation
SST
09308-00010
Oil Seal Puller
09554-47010
Oil Seal Replacer
09950-70010
Handle Set
(09951-07100)
Handle 100
09961-00950
Torque Wrench Adaptor
EQUIPMENT
Brass bar
-
Chisel
-
Dial indicator with magnetic base
-
Feeler gauge
-
Hammer
-
Micrometer
-
MP grease
-
Needle nose pliers
-
Plastic hammer
-
Press
-
Red lead
-
Screwdriver
-
Tape
-
Torque wrench
-
Vernier calipers
-
LUBRICANT / Recommended Viscosity
Item
Temperature
Viscosity
Front Differential
Rear Differential
Above -18°C (0°F)
SAE 90
Below -18°C (0°F)
SAE 80W-90 or SAE 80W
LUBRICANT / Differential Oil Type
Item
Oil type
Front Differential
Rear Differential
Hypoid gear oil API GL-5
LUBRICANT / Standard Differential Oil Capacity
Item
Specified Condition
Front Differential
1.40 to 1.50 liters (1.48 to 1.58 US qts., 1.23 to 1.32 Imp. qts.)
Rear Differential
3.30 to 3.40 liters (3.49 to 3.59 US qts., 2.91 to 2.99 Imp. qts.)
w/ Differential Lock
2.85 to 2.95 liters (3.01 to 3.12 US qts., 2.51 to 2.59 Imp. qts.)
4WD, Pre-Runner and made DANA
2.40 to 2.50 liters (2.54 to 2.64 US qts., 2.11 to 2.20 Imp. qts.)
RECOMMENDED TOOLS
09011-2C590
Socket Wrench
30mm/12p
-
09013-1C550
"TORX" Socket Wrench E-type
E14
-
09013-7C100
Straight Hexagon
10mm
-
09017-1C100
Union Nut Wrench
10mm
-
09051-1C400
Pin Punch
3
-
09905-00012
Snap Ring No. 1 Expander
-
09905-00013
Snap Ring Pliers
-
SSM
Toyota Genuine seal packing 1281, Three Bond 1281 or equivalent
-
Toyota Genuine Adhesive 1360K, Three Bond 1360K or equivalent
-
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
-