Home › Vehicle Exterior › BODY WELD POINT › REAR FLOOR PAN
BM33K0E _01 Vehicle Exterior _046210 BODY WELD POINT _0223730 REAR FLOOR PAN F

BODY WELD POINT  REAR FLOOR PAN  CUT AND JOIN REPLACEMENT SECTIONS  


K125177

With the body lower back panel cut and join replacement sections (small areas) and rear floor crossmember upper gusset assembly removed.


REMOVAL


Symbol Meaning
K108818

Remove Weld Points
K108820

Remove Weld Points
K108829

Cut Location

K125268C01
5.99,1.625 6.302,1.781 0.313,0.156 10 false *a
*a 305 mm (12.01 in.) - -


K125269C01
0.167,0.177 0.479,0.333 0.313,0.156 10 false *A
*A LH Side - -


K125270C01
0.167,0.177 0.479,0.333 0.313,0.156 10 false *A
*A RH Side - -



INSTALLATION


Symbol Meaning
K108823

Plug Weld
K108825

Plug Weld
K108829

Cut Location
K108834

Body Sealer

a.

Cut the new part so that it overlaps the previous cut location by approximately 20 mm (0.79 in.).

K125271C01
0.167,0.177 0.479,0.333 0.313,0.156 10 false *A 5.271,1.917 5.583,2.073 0.313,0.156 10 false *a
*A Upper Face - -
*a 285 mm (11.22 in.) - -



b.

Before temporarily installing the new parts, weld the rear floor pan and body lower back panel reinforce sub-assembly with the standard number of welding points.

K125272C01
4.573,2.052 4.833,2.417 4.833,2.417 5.083,2.417 false 3.656,2.406 3.917,2.771 3.917,2.771 4.167,2.771 false 0.167,0.177 0.479,0.333 0.313,0.156 10 false *A 5.135,2.344 5.448,2.5 0.313,0.156 10 false *1 4.219,2.688 4.531,2.844 0.313,0.156 10 false *2
*A Lower Face - -
*1 REAR FLOOR PAN *2 BODY LOWER BACK PANEL REINFORCE SUB-ASSEMBLY



c.

Perform plug-welding in the area where the panel are overlapped. Apply body sealer to both sides of each panel.

HINT:
·

Confirm that the panels are securely welded together.

·

Apply body sealer in an even, continuous bead.



K125273

K125274C01
0.188,0.177 0.5,0.333 0.313,0.156 10 false *A
*A LH Side - -


K125275C01
0.167,0.177 0.479,0.333 0.313,0.156 10 false *A
*A RH Side - -



d.

After welding, apply body sealer and undercoating to the corresponding parts. (See the painting/coating)


e.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.