FUNCTION
The ECM estimates the ethanol concentration of the fuel in the fuel tank based on the signals it receives from the air fuel sensor. When the engine is started, the ECM activates the glow plug via the glow plug controller, based on the water temperature and ethanol concentration in the memory. As a result, fuel of the optimum temperature is injected into the intake ports.
SYSTEM CONTROL
The glow plug control carries out the following controls:
When the ECM is activated by the courtesy switch (smart trigger system), it sends a signal to the glow plug controller. Based on this signal, the ECM decides whether the glow plug controller should heat the glow plug.
In accordance with the signals from the ECM, the glow plug controller applies current via the glow plug assembly to control the fuel temperature.
When the glow plug controller detects a malfunction in the glow circuit, it sends a diagnostic signal to the ECM.
Smart Trigger System
The smart trigger system is turned on by the main relay when the driver door is opened, operating the heater. As a result, it will complete heating before the driver turns the ignition switch to ON in the most case.