1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
74404B
3.REMOVE BATTERY CLAMP SUB-ASSEMBLY
Loosen the 2 nuts.
Remove the 2 battery clamp bolts and battery clamp sub-assembly.
28800
4.REMOVE BATTERY
74431
5.REMOVE BATTERY TRAY
17344E
6.REMOVE NO. 4 AIR HOSE
16361A
7.REMOVE FAN AND GENERATOR V BELT
27020
8.REMOVE GENERATOR ASSEMBLY
Disconnect the intake air temperature sensor connector.
Disconnect the generator connector and detach the clamp.
Remove the terminal cap.
Remove the nut and disconnect the wire harness from terminal B.
Detach the 3 clamps and disconnect the wire harness.
Remove the 2 bolts and generator assembly.
Remove the 2 bolts and 2 generator brackets.