84610F
1.INSPECT SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)
| *a | Shift Paddle Switch LH (Transmission Shift Switch Assembly LH) |
| *b | Shift Paddle Switch RH (Transmission Shift Switch Assembly RH) |
| *c | Component without harness connected
(Shift Paddle Switch (Transmission Shift Switch Assembly)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Shift Position | Specified Condition |
|---|---|---|
| SDN - ECC | "-" shift paddle operated and held (down-shift) | Below 3 Ω |
| SDN - ECC1 | "-" shift paddle operated and held (down-shift) | Below 3 Ω |
| SDN - ECC | "-" shift paddle not operated (down-shift) | 1 MΩ or higher |
| SDN - ECC1 | "-" shift paddle not operated (down-shift) | 1 MΩ or higher |
| Tester Connection | Shift Position | Specified Condition |
|---|---|---|
| SUP - ECC1 | "+" shift paddle operated and held (up-shift) | Below 3 Ω |
| SUP - ECC1 | "+" shift paddle not operated (up-shift) | 1 MΩ or higher |
If the result is not as specified, replace the shift paddle switch (transmission shift switch assembly).
84523
2.INSPECT NO. 1 SWITCH WIRE
Connect the No. 1 switch wire connector to the transmission shift switch assembly.
Disconnect the steering pad switch assembly connector from the No. 1 switch wire.
| *a | Front view of wire harness connector
(to Steering Pad Switch Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| SDN - ECC | "-" shift paddle operated and held (down-shift) | Below 3 Ω |
| SUP - ECC | "+" shift paddle operated and held (up-shift) | Below 3 Ω |
| SDN - ECC | "-" shift paddle not operated (down-shift) | 1 MΩ or higher |
| SUP - ECC | "+" shift paddle not operated (up-shift) | 1 MΩ or higher |
If the result is not as specified, replace the No. 1 switch wire.