Home › Audio / Visual / Telematics › AUDIO / VIDEO › FRONT DOOR SPEAKER
RM33K0E _56 Audio / Visual / Telematics _043541 AUDIO / VIDEO _0213893 FRONT DOOR SPEAKER A

AUDIO / VIDEO  FRONT DOOR SPEAKER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 86160 1.INSTALL FRONT NO. 1 SPEAKER ASSEMBLY

a.

Install a nose piece to an air riveter or hand riveter. Then insert the mandrel part of a new φ4 mm waterproof rivet into the nose piece.


b.
E339740

Using an air riveter or hand riveter, install the front No. 1 speaker assembly with 3 new rivets.

NOTICE:
·
B171664C07
1.229,1.104 1.083,1.635 1.083,1.635 1.24,2.198 false 1.083,1.635 0.813,1.635 false 1.792,0.896 2.031,1.635 2.031,1.635 1.771,2.531 false 2.031,1.635 2.313,1.635 false 2.26,0.604 2.521,0.802 0.26,0.198 10 *a 2.26,2.448 2.563,2.677 0.302,0.229 10 *b 2.344,1.563 2.594,1.781 0.25,0.219 10 *1 0.594,1.573 0.844,1.75 0.25,0.177 10 *2
*a INCORRECT
*b CORRECT
*1 Mandrel
*2 Riveter


Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.

·
B172390C18
0.719,0.104 1.021,0.104 false 0.813,1.146 1.01,1.146 false 0.813,2.438 1.01,2.438 false 2.313,0.563 2.646,0.875 0.333,0.313 10 false *a 2.313,2.76 2.573,3.01 0.26,0.25 10 false *b 1.052,2.365 1.323,2.573 0.271,0.208 10 false *1 2.313,1.573 2.698,1.917 0.385,0.344 10 false *a 1.052,1.073 1.302,1.344 0.25,0.271 10 false *1 1.052,0.021 1.313,0.25 0.26,0.229 10 false *1
*a INCORRECT
*b CORRECT
*1 Riveter


Confirm that the rivets are seated properly against the speaker.

·

Do not tilt the riveter when installing the rivet to the speaker.

·

Do not leave any space between the rivet head and speaker.

·
B172391C17
0.74,0.646 0.938,0.646 false 0.729,2.156 0.938,2.156 false 2.292,1.042 2.615,1.323 0.323,0.281 10 false *a 2.292,2.479 2.531,2.677 0.24,0.198 10 false *b 0.969,0.573 1.24,0.781 0.271,0.208 10 false *1 0.969,2.083 1.26,2.281 0.292,0.198 10 false *1
*a INCORRECT
*b CORRECT
*1 Riveter


Do not leave any space between the speaker and door. Firmly hold together the 2 items while installing the rivet.




c.

Connect the connector.


Hide 67602 2.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 69284C 3.INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

Hide 74220 4.INSTALL FRONT ARMREST ASSEMBLY LH

Hide 5.INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL

Hide 86160P 6.INSTALL FRONT NO. 2 SPEAKER ASSEMBLY

a.
E339738

Attach the claws to install the front No. 2 speaker assembly.


Hide 67492A 7.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

Hide 8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).