Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › STEERING PAD › 2015.11–2016.07
RM33K0E _58 Vehicle Interior _043552 SUPPLEMENTAL RESTRAINT SYSTEMS _0219473 STEERING PAD A

SUPPLEMENTAL RESTRAINT SYSTEMS  STEERING PAD  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 45130 1.INSTALL HORN BUTTON ASSEMBLY

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
B394718

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.




c.

Support the horn button assembly with one hand.


d.
B430722C01
1.938,3.052 2.542,2.771 true 1.76,2.979 2.073,3.135 0.313,0.156 10 false *a
*a Connector Lock
V113147

Push


Connect the airbag connector and lock the connector lock.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.



e.

Connect the horn connector.


f.

Set the horn button assembly to the steering wheel assembly.


g.

Check that the airbag wire harness and horn wire harness are not pinched.


h.
B430723C01
1.115,0.563 2.063,1.115 0.948,0.552 1.156,1.229 2,1.781 0.844,0.552 1.125,0.573 1.333,0.781 0.208,0.208 10 true *a 1.177,1.24 1.385,1.448 0.208,0.208 10 true *b
*a Upper Pin
*b Lower Pin


Press the horn button assembly with both hands to attach the upper pin to the torsion spring.


i.

Press the horn button assembly with both hands to attach the lower pin to the torsion spring.

NOTICE:

After installation, try to pull the horn button assembly and check that the horn button assembly is securely installed.



Hide 45186 2.INSTALL LOWER NO. 2 STEERING WHEEL COVER

a.
B404063

Attach the guide and claw to install the lower No. 2 steering wheel cover.


Hide 45187 3.INSTALL LOWER NO. 3 STEERING WHEEL COVER

a.
B404064

Attach the guide and claw to install the lower No. 3 steering wheel cover.


Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 45130 5.INSPECT HORN BUTTON ASSEMBLY

a.

With the horn button assembly installed to the vehicle, perform a visual check. If any of the defects mentioned below are found, replace the horn button assembly with a new one:

Cuts, minute cracks or marked discoloration on the horn button assembly top surface or in the grooved portion.


b.

Make sure that the horn sounds.

HINT:

If the horn does not sound, inspect the horn system.

Click hereVehicle Exterior>HORN>HORN SYSTEM>PROBLEM SYMPTOMS TABLE