The combination meter assembly sends an auto dimmer signal to the navigation receiver assembly via this circuit.
When the navigation receiver assembly receives an auto dimmer signal from the combination meter assembly, the panel switch of the navigation receiver assembly dims and the screen changes to the night screen.
Check that the wire harness is properly installed and does not have any sharp bends, pinching or loose connections.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
When replacing the combination meter assembly, make sure to replace it with a new one.
Disconnect the navigation receiver assembly connector.
| *a | Front view of wire harness connector
(to Navigation Receiver Assembly) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G41-3 (ADIM) - Body ground | Ignition switch ON
Automatic light control sensor covered by hand, and light control switch in tail or head position |
11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
NG
Disconnect the G41 navigation receiver assembly connector.
Disconnect the G8 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G8-4 (ACAN) - G41-3 (ADIM) | Always | Below 1 Ω |
| G8-4 (ACAN) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG