84140
1.INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY (for LHD)
Inspect the light control switch.
| *a | Component without harness connected
(Headlight Dimmer Switch Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G3-18 (T) - G3-15 (EL) | Light control switch off position | 10 kΩ or higher |
| G3-19 (H) - G3-15 (EL) | ||
| G3-20 (A) - G3-15 (EL) | Light control switch AUTO position | Below 1 Ω |
| G3-18 (T) - G3-15 (EL) | Light control switch tail position | Below 1 Ω |
| G3-19 (H) - G3-15 (EL) | Light control switch head position | Below 1 Ω |
| G3-18 (T) - G3-15 (EL) |
If the result is not as specified, replace the headlight dimmer switch assembly.
| *a | Component without harness connected
(Headlight Dimmer Switch Assembly) |
Inspect the headlight dimmer switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G3-14 (HU) - G3-15 (EL) | Headlight dimmer switch flash position | Below 1 Ω |
| G3-17 (HF) - G3-15 (EL) | ||
| G3-14 (HU) - G3-15 (EL) | Headlight dimmer switch high position | Below 1 Ω |
If the result is not as specified, replace the headlight dimmer switch assembly.
| *a | Component without harness connected
(Headlight Dimmer Switch Assembly) |
Inspect the turn signal light switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G3-12 (TR) - G3-15 (EL) | Turn signal switch neutral position | 10 kΩ or higher |
| G3-11 (TL) - G3-15 (EL) | ||
| G3-12 (TR) - G3-15 (EL) | Turn signal switch right turn position
(self cancel condition) |
Below 1 Ω |
| G3-12 (TR) - G3-15 (EL) | Turn signal switch right turn position
(cancel ratchet operation condition) |
Below 1 Ω |
| G3-12 (TR) - G3-13 (CR) | ||
| G3-13 (CR) - G3-15 (EL) | ||
| G3-11 (TL) - G3-15 (EL) | Turn signal switch left turn position
(self cancel condition) |
Below 1 Ω |
| G3-11 (TL) - G3-15 (EL) | Turn signal switch left turn position
(cancel ratchet operation condition) |
Below 1 Ω |
| G3-11 (TL) - G3-13 (CR) | ||
| G3-13 (CR) - G3-15 (EL) |
The self cancel condition indicates when the turn signal switch returns to the neutral position after releasing your hand from the switch (switch is operated within 7°).
The cancel ratchet operation condition indicates the condition when the turn signal switch does not return to the neutral position even after releasing your hand (switch operation is 12°).
If the result is not as specified, replace the headlight dimmer switch assembly.
Inspect the front fog light switch.
| *a | Component without harness connected
(Headlight Dimmer Switch Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G3-9 (BFG) - G3-8 (LFG) | Front fog light switch off | 10 kΩ or higher |
| G3-9 (BFG) - G3-8 (LFG) | Front fog light switch on | Below 1 Ω |
If the result is not as specified, replace the headlight dimmer switch assembly.
| *a | Component without harness connected
(Headlight Dimmer Switch Assembly) |
Inspect the rear fog light switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G3-7 (B) - G3-8 (LFG) | Rear fog light switch off | 10 kΩ or higher |
| G3-7 (B) - G3-9 (BFG) | ||
| G3-7 (B) - G3-8 (LFG) | Rear fog light switch on | Below 1 Ω |
| G3-7 (B) - G3-9 (BFG) |
If the result is not as specified, replace the headlight dimmer switch assembly.
84140
2.INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY (for RHD)
Inspect the light control switch.
| *a | Component without harness connected
(Headlight Dimmer Switch Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G3-11 (A) - G3-16 (EL) | Light control switch AUTO position | Below 1 Ω |
| G3-13 (T) - G3-16 (EL) | Light control switch tail position | Below 1 Ω |
| G3-12 (H) - G3-16 (EL) | Light control switch head position | Below 1 Ω |
| G3-13 (T) - G3-16 (EL) |
If the result is not as specified, replace the headlight dimmer switch assembly.
| *a | Component without harness connected
(Headlight Dimmer Switch Assembly) |
Inspect the headlight dimmer switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G3-14 (HF) - G3-16 (EL) | Headlight dimmer switch flash position | Below 1 Ω |
| G3-17 (HU) - G3-16 (EL) | ||
| G3-17 (HU) - G3-16 (EL) | Headlight dimmer switch high position | Below 1 Ω |
If the result is not as specified, replace the headlight dimmer switch assembly.
| *a | Component without harness connected
(Headlight Dimmer Switch Assembly) |
Inspect the turn signal light switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G3-20 (TR) - G3-16 (EL) | Turn signal switch neutral position | 10 kΩ or higher |
| G3-19 (TL) - G3-16 (EL) | ||
| G3-20 (TR) - G3-16 (EL) | Turn signal switch right turn position
(self cancel condition) |
Below 1 Ω |
| G3-20 (TR) - G3-16 (EL) | Turn signal switch right turn position
(cancel ratchet operation condition) |
Below 1 Ω |
| G3-20 (TR) - G3-18 (CR) | ||
| G3-18 (CR) - G3-16 (EL) | ||
| G3-19 (TL) - G3-16 (EL) | Turn signal switch left turn position
(self cancel condition) |
Below 1 Ω |
| G3-19 (TL) - G3-16 (EL) | Turn signal switch left turn position
(cancel ratchet operation condition) |
Below 1 Ω |
| G3-19 (TL) - G3-18 (CR) | ||
| G3-18 (CR) - G3-16 (EL) |
The self cancel condition indicates when the turn signal switch returns to the neutral position after releasing your hand from the switch (switch is operated within 7°).
The cancel ratchet operation condition indicates the condition when the turn signal switch does not return to the neutral position even after releasing your hand (switch operation is 12°).
If the result is not as specified, replace the headlight dimmer switch assembly.
| *a | Component without harness connected
(Headlight Dimmer Switch Assembly) |
Inspect the front fog light switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G3-2 (BFG) - G3-3 (LFG) | Front fog light switch off | 10 kΩ or higher |
| G3-2 (BFG) - G3-3 (LFG) | Front fog light switch on | Below 1 Ω |
If the result is not as specified, replace the headlight dimmer switch assembly.