Home › Vehicle Exterior › LIGHTING (EXT) › HEIGHT CONTROL SENSOR
RM33K0E _59 Vehicle Exterior _043562 LIGHTING (EXT) _0219507 HEIGHT CONTROL SENSOR G

LIGHTING (EXT)  HEIGHT CONTROL SENSOR  INSPECTION  


PROCEDURE

Hide 89408C 1.INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

a.

Check the rear height control sensor sub-assembly LH.

i.

Connect 3 dry batteries of 1.5 V in series.


ii.

Connect the positive (+) end of the batteries to terminal 3 (SHB) of the rear height control sensor sub-assembly LH and the negative (-) end of the batteries to terminal 1 (SHG). While slowly moving the sensor link up and down, measure the voltage between terminal 2 (SHRR) and terminal 1 (SHG).

NOTICE:
·

Do not use rechargeable batteries as they may not output a voltage of 1.5 V.

·

Do not apply a voltage of more than 6 V.



E319915C01
5.167,1.094 5.49,1.344 0.323,0.25 5.969,2.771 5.656,2.104 true 4.792,2.688 5.031,2.115 true 5.188,2.823 5.26,2.115 true 4.573,0.948 4.885,1.104 0.313,0.156 10 false *a 3.563,0.656 3.875,0.813 0.313,0.156 10 false *b 4.24,1.75 4.552,1.906 0.313,0.156 10 false *c 4.177,1.573 4.49,1.729 0.313,0.156 10 false *d 4.167,3.177 4.479,3.333 0.313,0.156 10 false *e 3.667,1.333 3.979,1.49 0.313,0.156 10 false *f 3.969,2.5 4.281,2.729 0.313,0.229 10 false *g 5.25,1.125 5.563,1.323 0.313,0.198 10 false O7 4.99,2.875 5.49,3.073 0.5,0.198 10 false SHRR 5.875,2.813 6.375,3.01 0.5,0.198 10 false SHG 4.635,2.719 5.135,2.917 0.5,0.198 10 false SHB
*a Component without harness connected
(Rear Height Control Sensor Sub-assembly LH)
*b Vehicle Height is Low (Full Bound)
*c Vehicle Standard Position *d Sensor Standard Position
*e Vehicle Height is High (Full Rebound) *f +28.62°
*g -39.27° - -



iii.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
O7-1 (SHG) - O7-2 (SHRR) +28.62° (Vehicle Height is Low) Approx. 1.2 V
0° (Sensor Standard position) Approx. 2.5 V
-39.27° (Vehicle Height is High) Approx. 4.0 V


If the result is not as specified, replace the rear height control sensor sub-assembly LH.