84840G
1.INSPECT BACK DOOR OPENER SWITCH ASSEMBLY
Check the resistance.
| *a | Component without harness connected
(Back Door Opener Switch Assembly) |
| *b | Open Switch |
| *c | Lock Switch |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 2 (E) - 3 (UL) | Back door opener switch not pushed (OFF) | 10 kΩ or higher |
| 2 (E) - 3 (UL) | Back door opener switch pushed (ON) | Below 1 Ω |
If the result is not as specified, replace the back door opener switch assembly.
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 (L) - 2 (E) | Back door lock switch not pushed (OFF) | 10 kΩ or higher |
| 1 (L) - 2 (E) | Back door lock switch pushed (ON) | Below 1 Ω |
If the result is not as specified, replace the back door opener switch assembly.