Home › Vehicle Exterior › DOOR / HATCH › POWER BACK DOOR CONTROL SWITCH
RM33K0E _59 Vehicle Exterior _043559 DOOR / HATCH _0219601 POWER BACK DOOR CONTROL SWITCH G

DOOR / HATCH  POWER BACK DOOR CONTROL SWITCH  INSPECTION  


PROCEDURE

Hide 84931C 1.INSPECT BACK DOOR CONTROL SWITCH

a.

Check the resistance.

i.
B408905C01
1.708,2.229 1.906,1.708 1.906,1.708 2.125,1.708 true 1.448,2.219 1.229,1.698 1.229,1.698 0.99,1.698 true 0.563,3.104 0.823,3.104 0.823,3.104 1.219,2.417 true 2.604,3.104 2.354,3.104 2.354,3.104 1.948,2.417 true 0.698,1.615 1.313,1.813 0.615,0.198 10 false ILL- 2.167,1.635 2.781,1.833 0.615,0.198 10 false ILL+ 0.406,3.021 0.563,3.219 0.156,0.198 10 false E 2.646,3.021 3.104,3.219 0.458,0.198 10 false CLS 0.156,1.698 0.469,1.896 0.313,0.198 10 false *a
*a Component without harness connected
(Back Door Control Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
4(CLS) - 1 (E) Switch off 10 kΩ or higher
Switch on Below 1 Ω


If the result is not as specified, replace the back door control switch.



b.

Inspect the illumination operation.

i.

Apply battery voltage to the power back door control switch connector, and check that the back door control switch LED illuminates.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 3 (ILL+)
Battery negative (-) → Terminal 2 (ILL-)
LED illuminates


If the result is not as specified, replace the back door control switch.