Home › Vehicle Exterior › DOOR / HATCH › POWER BACK DOOR CONTROL SWITCH(for Instrument Panel)
RM33K0E _59 Vehicle Exterior _043559 DOOR / HATCH _0219602 POWER BACK DOOR CONTROL SWITCH(for Instrument Panel) G

DOOR / HATCH  POWER BACK DOOR CONTROL SWITCH(for Instrument Panel)  INSPECTION  


PROCEDURE

Hide 84930 1.INSPECT DOOR CONTROL SWITCH ASSEMBLY

a.

Check the resistance.

i.
B408903C01
0.906,3.219 1.323,2.802 true 2.583,3.208 2.135,2.792 true 0.51,3.104 0.969,3.302 0.458,0.198 10 false CSW 2.646,3.125 3.104,3.323 0.458,0.198 10 false E 0.385,1.813 0.698,2.01 0.313,0.198 10 false *a
*a Component without harness connected
(Door Control Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 (E) - 4 (CSW) Back door control switch assembly not pushed 10 kΩ or higher
1 (E) - 4 (CSW) Back door control switch assembly pushed Below 1 Ω


If the result is not as specified, replace the door control switch assembly.



b.
B408904C01
1.156,3.208 1.573,2.792 true 2.24,3.219 1.854,2.802 true 0.875,3.167 1.49,3.365 0.615,0.198 10 false ILL+ 2.292,3.156 2.906,3.354 0.615,0.198 10 false ILL- 0.313,1.823 0.625,2.021 0.313,0.198 10 false *a
*a Component without harness connected
(Door Control Switch Assembly)


Inspect the illumination operation.

i.

Apply battery voltage to the door control switch assembly connector, and check that the door control switch assembly LED illuminates.

OK:
Measurement Condition Specified Condition
Battery positive (+) → 3 (ILL+)
Battery negative (-) → 2 (ILL-)
LED illuminates


If the result is not as specified, replace the door control switch assembly.