Home › Vehicle Interior › HEATING / AIR CONDITIONING › PRESSURE SWITCH
RM33K0E _58 Vehicle Interior _043555 HEATING / AIR CONDITIONING _0219902 PRESSURE SWITCH G

HEATING / AIR CONDITIONING  PRESSURE SWITCH  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 88645H 1.INSPECT NO. 1 PRESSURE SWITCH

a.

Disconnect the connector.


b.
E075701C04
0.938,0.906 1.219,0.906 1.219,0.906 1.552,1.333 true 2.365,0.896 2.125,0.896 2.125,0.896 1.865,1.323 true 0.042,0.042 0.24,0.25 0.198,0.208 10 false *a 0.708,0.813 1.021,1.01 0.313,0.198 10 false S+ 2.438,0.823 2.75,1.021 0.313,0.198 10 false S-
*a Front view of wire harness connector
(No. 1 Pressure Switch)


Using a service wire, connect terminals 1 (S+) and 2 (S-) of the No. 1 pressure switch connector on the vehicle wire harness side.


c.

Start the engine.


d.

Turn the A/C switch on and check that the magnet clutch turns on.


e.

Check that the magnet clutch turns off when disconnecting terminals 1 (S+) and 2 (S-).

OK:
Measurement Condition Specified Condition
Terminals 1 (S+) and 2 (S-) connected Magnet clutch turns on
Terminals 1 (S+) and 2 (S-) disconnected Magnet clutch turns off


If the result is not as specified, replace the No. 1 pressure switch.