87710G
1.INSPECT QUICK HEATER ASSEMBLY
| *a | Component without harness connected
(Quick Heater Assembly) |
| *b | Connector A |
| *c | Connector B |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A-1 (B) - B-1 (E) | Always | Below 1 Ω |
| A-2 (E) - B-2 (B) | Always | Below 1 Ω |
| A-3 (B) - B-1 (E) | Always | Below 1 Ω |
| A-3 (B) - B-2 (B) | Always | Below 1 Ω |
If the result is not as specified, replace the quick heater assembly.