Home › Engine / Hybrid System › 1KD-FTV FUEL › COMMON RAIL
RM33K0E _51 Engine / Hybrid System _043573 1KD-FTV FUEL _0220764 COMMON RAIL A

1KD-FTV FUEL  COMMON RAIL  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the parts in the following chart (A), replace the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly, No. 3 injection pipe sub-assembly, No. 4 injection pipe sub-assembly and/or fuel inlet pipe sub-assembly with new ones.

Replaced Parts (A) Pipes Requiring New Replacement
·

Injector assembly (including shuffling the injector assemblies between the cylinders)

·

Common rail assembly

·

Cylinder head sub-assembly


·

No. 1 injection pipe sub-assembly

·

No. 2 injection pipe sub-assembly

·

No. 3 injection pipe sub-assembly

·

No. 4 injection pipe sub-assembly


·

Supply pump assembly

·

Common rail assembly

·

Cylinder block sub-assembly

·

Cylinder head sub-assembly

·

Cylinder head gasket

·

Timing Gear Case Assembly


Fuel inlet pipe sub-assembly

·

After removing the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly, No. 3 injection pipe sub-assembly, No. 4 injection pipe sub-assembly and fuel inlet pipe sub-assembly, clean them with a brush and compressed air.

·

When replacing the common rail assembly, do not remove the foreign object mixing prevention caps of the common rail assembly until just before the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly, No. 3 injection pipe sub-assembly, No. 4 injection pipe sub-assembly and fuel inlet pipe sub-assembly are connected to the common rail assembly.



PROCEDURE

Hide 17136 1.INSTALL NO. 2 INTAKE MANIFOLD INSULATOR

a.

Install the No. 2 intake manifold insulator to the cylinder head sub-assembly.


Hide 23810A 2.INSTALL COMMON RAIL ASSEMBLY

a.

Install the common rail assembly to the cylinder head sub-assembly with the 2 bolts.

Torque:
38 N*m (387 kgf*cm, 28 ft.*lbf)


b.

Connect the connector to the pressure discharge valve.


c.

Connect the connector to the fuel pressure sensor connector.


Hide 23804C 3.INSTALL FUEL INLET PIPE SUB-ASSEMBLY

Hide 11452 4.INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE

Hide 23770 5.INSTALL NO. 2 NOZZLE LEAKAGE PIPE ASSEMBLY

Hide 23704 6.INSTALL NO. 4 INJECTION PIPE SUB-ASSEMBLY

Hide 23701 7.INSTALL NO. 1, NO. 2 AND NO. 3 INJECTION PIPE SUB-ASSEMBLY

Hide 15601 8.INSTALL OIL FILTER SUB-ASSEMBLY

Hide 17940D 10.INSTALL INTERCOOLER ASSEMBLY

Hide 12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 51442 17.INSTALL NO. 2 ENGINE UNDER COVER

Hide 51410 18.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY