Home › Engine / Hybrid System › 2TR-FE ENGINE CONTROL › KNOCK SENSOR
RM33K0E _51 Engine / Hybrid System _043567 2TR-FE ENGINE CONTROL _0220952 KNOCK SENSOR A

2TR-FE ENGINE CONTROL  KNOCK SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the knock sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of knock sensor Inspection After Repair Poor idle, engine start, etc. (Click here)

PROCEDURE

Hide 89615 2.REMOVE KNOCK SENSOR

a.

Disconnect the knock sensor connector.


b.
A345930

Remove the bolt and knock sensor.