Home › Engine / Hybrid System › 1GR-FE INTAKE / EXHAUST › INTAKE MANIFOLD
RM33K0E _51 Engine / Hybrid System _043578 1GR-FE INTAKE / EXHAUST _0220969 INTAKE MANIFOLD A

1GR-FE INTAKE / EXHAUST  INTAKE MANIFOLD  REMOVAL  


PROCEDURE

Hide 1.DISCHARGE FUEL SYSTEM PRESSURE

Hide 17705 4.REMOVE AIR CLEANER CAP SUB-ASSEMBLY WITH NO. 1 AIR CLEANER HOSE

Hide 5.REMOVE V-BANK COVER BRACKET

a.
A344379

Remove the 2 bolts and V-bank cover bracket.


Hide 17129 6.REMOVE INTAKE AIR SURGE TANK

a.
A356021

Slide the clip and disconnect the No. 4 water by-pass hose from the throttle body with motor assembly.


b.

Slide the clip and disconnect the No. 5 water by-pass hose from the throttle body with motor assembly.


c.

Disconnect the throttle body with motor connector.


d.
A344375

Slide the clip and disconnect the fuel vapor feed hose from the purge VSV.


e.

Disconnect the connector and detach the wire harness clamp.


f.
A344374

Disconnect the connector and detach the 2 wire harness clamps.


g.
A344376

Slide the clip and disconnect the No. 1 PCV hose from the intake air surge tank.


h.

Slide the clip and disconnect the purge line hose from the intake air surge tank.


i.
A358534

Detach the 2 wire harness clamps.


j.
A344377

Remove the 2 bolts and disconnect the water hose sub-assembly.


k.
A344380

Remove the 2 bolts and throttle body bracket.


l.
A344381

Remove the bolt and oil baffle plate.


m.
A344382

Remove the 2 bolts and No. 1 surge tank stay.


n.
A344385

Remove the 2 bolts and No. 2 surge tank stay.


o.
A344383

Using an 8 mm hexagon wrench, remove the 4 bolts, 2 nuts and intake air surge tank and gasket.


Hide 23801P 7.DISCONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY

Hide 23802B 8.DISCONNECT NO. 2 FUEL PIPE SUB-ASSEMBLY

Hide 23807 9.REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY

Hide 17111 10.REMOVE INTAKE MANIFOLD

a.
A344384

Remove the 10 bolts, intake manifold and 2 gaskets.


Hide 11.REMOVE STUD BOLT

NOTICE:

If a stud bolt is deformed or its threads are damaged, replace it.


a.

Using an E7 "TORX" socket wrench, remove the 2 stud bolts from the intake manifold.