Home › Engine / Hybrid System › 1GR-FE INTAKE / EXHAUST › EXHAUST MANIFOLD
RM33K0E _51 Engine / Hybrid System _043578 1GR-FE INTAKE / EXHAUST _0220971 EXHAUST MANIFOLD A

1GR-FE INTAKE / EXHAUST  EXHAUST MANIFOLD  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the air fuel ratio sensor, exhaust manifold sub-assembly LH, exhaust manifold sub-assembly RH, front exhaust pipe assembly and front No. 2 exhaust pipe assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
·

Replacement of air fuel ratio sensor

·

Gas leaks from exhaust system


Inspection After Repair Poor idle, engine start, etc. (Click here)

CAUTION:
·
A358535

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.

·
A358533

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.



PROCEDURE

Hide 53735B 1.REMOVE FRONT UPPER FENDER APRON SEAL LH

Hide 53735B 2.REMOVE FRONT UPPER FENDER APRON SEAL RH

Hide 53882F 3.REMOVE FRONT FENDER SEAL LH

Hide 53882F 4.REMOVE FRONT FENDER SEAL RH

Hide 17450B 5.REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY

Hide 17410 6.REMOVE FRONT EXHAUST PIPE ASSEMBLY

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


a.
A374940

Disconnect the heated oxygen sensor connector.


b.

Detach the 2 clamps.


c.

Remove the 2 bolts, 2 compression springs and 2 nuts.


d.

Disconnect the No. 1 exhaust pipe support and remove the front exhaust pipe assembly.


e.

Remove the 2 gaskets.


Hide 17119 8.REMOVE NO. 2 MANIFOLD STAY

CAUTION:

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


a.

Remove the 3 bolts and No. 2 manifold stay.


Hide 17105 9.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH

CAUTION:

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


a.

Disconnect the air fuel ratio sensor connector.


b.
A346118

Remove the 6 nuts, exhaust manifold sub-assembly LH and gasket.


Hide 89467B 10.REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)

Hide 17118 11.REMOVE MANIFOLD STAY

CAUTION:

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


a.

Remove the 3 bolts and manifold stay.


Hide 17104 12.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH

CAUTION:

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


a.

Disconnect the air fuel ratio sensor connector.


b.
A346119

Remove the 6 nuts, exhaust manifold sub-assembly RH and gasket.


Hide 89467B 13.REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)