Home › Drivetrain › A750F AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSMISSION SYSTEM
RM33K0E _52 Drivetrain _043590 A750F AUTOMATIC TRANSMISSION / TRANSAXLE _0221981 AUTOMATIC TRANSMISSION SYSTEM D

A750F AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM  HYDRAULIC TEST  


PERFORM HYDRAULIC TEST


a.

Measure the line pressure.

CAUTION:

The line pressure test should always be carried out in pairs. One technician should observe the conditions of the wheels and wheel stoppers from outside the vehicle while the other is performing the test.


NOTICE:
·

Perform the test while the Automatic Transmission Fluid (ATF) temperature is between 50 and 80°C (122 and 176°F).

·

Be careful to prevent the hose of SST from interfering with the exhaust pipe.

·

This check must be conducted after checking and adjusting the engine.

·

Perform the test with the air conditioning off.

·

When conducting the stall test, do not continue for more than 5 seconds.

·

When performing the stall speed test more than once, make sure to wait 15 seconds or more between tests.



i.

Warm up the Automatic Transmission Fluid (ATF).


ii.

Turn the ignition switch off.


iii.

Lift the vehicle up.


iv.
C325985E01
0.563,0.729 0.396,0.469 true 0.5,0.76 0.958,0.958 0.458,0.198 10 false SST 3.042,0.74 3.375,0.906 0.333,0.167 10 false SST

Remove the test plug from the transmission case and connect SST.

SST
09993-19015  (09993-00010, 09993-00040)


v.

Lower the vehicle.


vi.

Fully apply the parking brake and chock the 4 wheels.


vii.

Start the engine and check the idling speed.


viii.

Keep your left foot pressed firmly on the brake pedal and move the shift lever to D.


ix.

Fully depress the accelerator pedal with your right foot. Quickly read the highest line pressure when the engine speed reaches the stall speed.


x.

In the same manner, perform the test with the shift lever in R.

Specified Line Pressure
Condition D Position R Position
Stall speed 1250 to 1500 kPa
(12.7 to 15.2 kgf/cm2, 181 to 218 psi)
1150 to 1450 kPa
(11.7 to 14.8 kgf/cm2, 166 to 211 psi)

Evaluation
Problem Possible Cause
Measured values at all positions are higher than specified pressure
·

Shift solenoid valve SLT defective

·

Regulator valve defective


Measured values at all positions are below specified pressure
·

Shift solenoid valve SLT defective

·

Regulator valve defective

·

Oil pump defective


Pressure is low in D only
·

D position circuit fluid leak

·

Clutch No. 1 (C1) defective


Pressure is low in R only
·

R position circuit fluid leak

·

Clutch No. 3 (C3) defective

·

Brake No. 4 (B4) defective