Home › Engine / Hybrid System › 1KD-FTV ENGINE CONTROL › MASS AIR FLOW METER
RM33K0E _51 Engine / Hybrid System _043566 1KD-FTV ENGINE CONTROL _0222117 MASS AIR FLOW METER G

1KD-FTV ENGINE CONTROL  MASS AIR FLOW METER  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

Perform the mass air flow meter inspection according to the procedures below.

·

Only replace the mass air flow meter when the mass air flow value in the Data List is not within the normal operating range (with the engine stopped) or there is foreign matter on the mass air flow meter platinum hot wire (heater).



PROCEDURE

Hide 22204 1.INSPECT MASS AIR FLOW METER

a.

Read the value using the GTS (MAF).

NOTICE:
·

Perform the inspection with the vehicle indoors and on a level surface.

·

Perform the inspection of the mass air flow meter while it is installed to the air cleaner case (installed to the vehicle).

·

During the test, do not use the exhaust air duct to perform suction on the exhaust pipe.



i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON (do not start the engine).


iii.

Turn the GTS on.


iv.

Enter the following menus: Powertrain / Engine / Data List / MAF.

Powertrain > Engine > Data List
Tester Display
MAF
50003 234 3

v.

Wait 30 seconds, and then read the values on the GTS.

Standard:

Less than 0.49 g/sec.


·

If the result is not as specified, replace the mass air flow meter.

·

If the result is within the specified range, inspect the mass air flow meter (See page Engine / Hybrid System>1KD-FTV ENGINE CONTROL>MASS AIR FLOW METER>INSPECTION).