89421C
1.INSPECT MANIFOLD ABSOLUTE PRESSURE SENSOR
Inspect the power source voltage.
Disconnect the manifold absolute pressure sensor connector.
| *a | Front view of wire harness connector
(to Manifold Absolute Pressure Sensor) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 3 VC (+) - 1 E (-) | Ignition switch ON | 4.75 to 5.25 V |
If the result is not as specified, inspect the wire harness or ECM (Click here Engine / Hybrid System>1KD-FTV ENGINE CONTROL>ECD SYSTEM>TERMINALS OF ECM).
Connect the manifold absolute pressure sensor connector.
| *a | Component with harness connected
(ECM) |
Check the power supply.
Turn the ignition switch to ON.
Disconnect the vacuum hose from the manifold absolute pressure sensor.
| *1 | Vacuum Pump |
|
Vacuum |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C74-28 (PIM +) - C73-28 (E2 -) | 13.3 kPa (100 mmHg, 3.94 in.Hg) | 0.0 to 0.3 V |
| 26.6 kPa (199 mmHg, 7.85 in.Hg) | 0.2 to 0.6 V | |
| 40 kPa (300 mmHg, 11.81 in.Hg) | 0.4 to 0.8 V |
The values in the "Condition" column are gauge pressures.
If the result is not as specified, replace the manifold absolute pressure sensor.
|
Pressure |
Using SST, measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C74-28 (PIM +) - C73-28 (E2) | 19.6 kPa (0.20 kgf/cm2, 2.84 psi) | 0.05 to 0.3 V |
| 39.2 kPa (0.40 kgf/cm2, 5.68 psi) | 0.25 to 0.55 V | |
| 58.8 kPa (0.60 kgf/cm2, 8.53 psi) | 0.45 to 0.75 V | |
| 78.5 kPa (0.80 kgf/cm2, 11.4 psi) | 0.65 to 0.95 V | |
| 98.0 kPa (1.00 kgf/cm2, 14.2 psi) | 0.9 to 1.2 V |
The values in the "Condition" column are gauge pressures.
If the result is not as specified, replace the manifold absolute pressure sensor.