Home › Vehicle Interior › DOOR LOCK › FRONT DOOR LOCK
RM33K0E _58 Vehicle Interior _043547 DOOR LOCK _0222452 FRONT DOOR LOCK A

DOOR LOCK  FRONT DOOR LOCK  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front door lock removal/installation are shown below.

Necessary Procedures After Parts Removed / Installed / Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative battery terminal
w/ Power Back Door System:

Reset back door close position


Power back door system (Click here)

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

Use the same procedure for RHD and LHD vehicles.

·

The procedures listed below are for LHD vehicles.

·

Fully open the front door glass sub-assembly LH before proceeding with work.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:
w/ Curtain Shield Airbag:
B394719

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type A)>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
w/ Curtain Shield Airbag:
B394718

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 67492A 3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

Hide 74220 4.REMOVE FRONT ARMREST ASSEMBLY LH

Hide 5.REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

Hide 6.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

Hide 69284C 7.REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

Hide 67602 8.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 67832 9.REMOVE FRONT DOOR SERVICE HOLE COVER LH

Hide 68151C 10.REMOVE FRONT DOOR GLASS RUN LH

Hide 68102 11.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

Hide 67404F 12.REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH

Hide 13.REMOVE FRONT DOOR OUTSIDE HANDLE COVER WITH LOCK CYLINDER ASSEMBLY (for Driver Side)

Hide 69320 14.REMOVE FRONT DOOR LOCK ASSEMBLY LH

a.
B438873C01
0,0 0,0 false
V100135

"Torx" Screw
V100136

Connector


Disconnect the connector.


b.

Using a T30 "TORX" socket wrench, remove the 3 screws.


c.
B438874C01
1.719,1.052 2.229,1.052 true 2.198,0.969 2.51,1.167 0.313,0.198 10 true *1
*1 front door lock open rod LH
V113147

Remove in this Direction


Disconnect the front door lock open rod LH and remove the front door lock assembly LH as shown in the illustration.


Hide 69036A 15.REMOVE FRONT DOOR LOCK COVER SUB-ASSEMBLY LH

a.
B438872C01
0,0 0,0 false
V100155

Protective Tape


Using a thin-bladed screwdriver, detach the claw and clamp and remove the front door lock cover sub-assembly LH from the front door lock assembly LH.

HINT:

Tape the thin-bladed screwdriver tip before use.



Hide 69760C 16.REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH

a.
B438876C01
0,0 0,0 false
V113147

Remove in this Direction


Detach the guide and remove the front door inside locking cable assembly LH from the front door lock assembly LH.


Hide 69720B 17.REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

a.
B438877C01
0,0 0,0 false
V113147

Remove in this Direction


Detach the guide and remove the front door lock remote cable assembly LH from the front door lock assembly LH.


Hide 69318C 18.REMOVE DOOR LOCK WIRING HARNESS SEAL

a.
B438878C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the door lock wiring harness seal from the front door lock assembly LH.