69320
1.INSPECT FRONT DOOR LOCK ASSEMBLY LH
| *a | Unlock |
| *b | Lock |
| *c | Component without harness connected
(Front Door Lock Assembly LH) |
Check the door lock motor operation.
Apply battery voltage to the motor connector and check the operation of the door lock motor.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 4 (L)
Battery negative (-) → Terminal 1 (UL) |
Lock |
| Battery positive (+) → Terminal 1 (UL)
Battery negative (-) → Terminal 4 (L) |
Unlock |
If the result is not as specified, replace the front door lock assembly LH.
Check the resistance of the door unlock detection switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 7 (E) - 8 (LSSR) | Lock | 10 kΩ or higher |
| Unlock | Below 1 Ω |
If the result is not as specified, replace the front door lock assembly LH.
| *a | Unlock |
| *b | Neutral |
| *c | Lock |
| *d | Component without harness connected
(Front Door Lock Assembly LH) |
Check the resistance of the lock and unlock switch (for LHD).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 9 (L) - 7 (E) | Lock | Below 1 Ω |
| 9 (L) - 7 (E)
10 (UL) - 7 (E) |
Neutral | 10 kΩ or higher |
| 10 (UL) - 7 (E) | Unlock | Below 1 Ω |
If the result is not as specified, replace the front door lock assembly LH.
69310
2.INSPECT FRONT DOOR LOCK ASSEMBLY RH
| *a | Unlock |
| *b | Lock |
| *c | Component without harness connected
(Front Door Lock Assembly RH) |
Check the door lock motor operation.
Apply battery voltage to the motor connector and check the operation of the door lock motor.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 4 (L)
Battery negative (-) → 1 (UL) |
Lock |
| Battery positive (+) → 1 (UL)
Battery negative (-) → 4 (L) |
Unlock |
If the result is not as specified, replace the front door lock assembly RH.
Check the resistance of the door unlock detection switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 7 (LSSR) - 8 (E) | Lock | 10 kΩ or higher |
| 7 (LSSR) - 8 (E) | Unlock | Below 1 Ω |
If the result is not as specified, replace the front door lock assembly RH.
| *a | Unlock |
| *b | Neutral |
| *c | Lock |
| *d | Component without harness connected
(Front Door Lock Assembly RH) |
Check the resistance of the lock and unlock switch (for RHD).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 6 (L) - 8 (E) | Held to lock side | Below 1 Ω |
| 6 (L) - 8 (E)
5 (UL) - 8 (E) |
Neutral | 10 kΩ or higher |
| 5 (UL) - 8 (E) | Held to unlock side | Below 1 Ω |
If the result is not as specified, replace the front door lock assembly RH.