Home › Brake › BRAKE (FRONT) › FRONT BRAKE
RM33K0E _54 Brake _043535 BRAKE (FRONT) _0223433 FRONT BRAKE A

BRAKE (FRONT)  FRONT BRAKE  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.DRAIN BRAKE FLUID

NOTICE:

Wash off brake fluid immediately if it comes in contact with any painted surface.


Hide 04947 3.REMOVE FRONT DISC BRAKE ANTI-RATTLE SPRING

a.
C326951C01
1.104,0.458 0.792,0.458 true 1.313,2.031 0.938,1.719 0.938,1.719 0.76,1.719 true 2.438,1.698 2.729,1.698 false 2.313,0.208 2.594,0.208 true 2.177,0.969 2.677,0.969 true 0.531,0.396 0.76,0.563 0.229,0.167 10 true *1 2.792,1.625 3.01,1.802 0.219,0.177 10 false *2 2.708,0.896 2.906,1.083 0.198,0.188 10 true *3 2.635,0.115 2.854,0.292 0.219,0.177 10 true *2 0.49,1.656 0.719,1.823 0.229,0.167 10 true *1
*1 Disc Brake Pad Guide Pin
*2 Pin Hold Clip
*3 Front Disc Brake Anti-rattle Spring


Remove the 2 pin hold clips and 2 disc brake pad guide pins.


b.

Remove the front disc brake anti-rattle spring.

NOTICE:

The front disc brake anti-rattle spring can be reused if it has sufficient rebound; no deformation, cracks or wear; and has all rust, dirt and foreign matter cleaned off.



Hide 04465 4.REMOVE FRONT DISC BRAKE PAD

a.

Remove the 2 front disc brake pads from the disc brake cylinder assembly LH.


Hide 04945 5.REMOVE FRONT ANTI-SQUEAL SHIM KIT

a.

Remove the 2 front No. 1 anti-squeal shims from each pad.


Hide 47343A 6.DISCONNECT FRONT NO. 1 WHEEL CYLINDER TUBE LH

a.
C321909

Using a union nut wrench, disconnect the front No. 1 wheel cylinder tube LH from the disc brake cylinder assembly LH.


Hide 47750 7.REMOVE DISC BRAKE CYLINDER ASSEMBLY LH

a.
C321910

Remove the 2 bolts and disc brake cylinder assembly LH.


Hide 43512 8.REMOVE FRONT DISC

a.
C321911C01
1.719,1.208 1.708,0.854 1.708,0.854 2.833,0.854 true 1.729,1.292 2.375,1.292 2.375,1.292 2.375,0.865 true 2.927,0.781 3.125,0.948 0.198,0.167 10 false *a
*a Matchmark


Put matchmarks on the front disc and axle hub.


b.

Remove the front disc.