Operating the iMT switch illuminates the iMT indicator light in the combination meter. This displays the iMT system standby condition.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Data List
According to the display on the GTS, read the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| iMT Switch | iMT switch status | ON or OFF | ·
ON: iMT switch being pressed and held ·
OFF: iMT switch not pressed |
- |
| Tester Display |
|---|
| iMT Switch |
| Result | Proceed to |
|---|---|
| Data display is within Normal Condition range | A |
| Data display is not within Normal Condition range | B |
A
Click hereDrivetrain>RC61F MANUAL TRANSMISSION / TRANSAXLE>MANUAL TRANSMISSION SYSTEM>PROBLEM SYMPTOMS TABLE
B
| *a | Front view of wire harness connector
(to iMT Switch) |
Disconnect the transmission revolution sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I5-2 (E) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the iMT switch connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I5-6 (S) - G49-8 (MTMS) | Always | Below 1 Ω |
| I5-6 (S) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Inspect the iMT switch.
Click hereDrivetrain>RC61F MANUAL TRANSMISSION / TRANSAXLE>INTELLIGENT MANUAL TRANSMISSION SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereDrivetrain>RC61F MANUAL TRANSMISSION / TRANSAXLE>MANUAL TRANSMISSION SYSTEM>PROBLEM SYMPTOMS TABLE
NG
Click hereDrivetrain>RC61F MANUAL TRANSMISSION / TRANSAXLE>INTELLIGENT MANUAL TRANSMISSION SWITCH>REMOVAL