The transponder key ECU assembly blinks the security indicator light when the immobiliser is set.
If the transponder key ECU assembly is replaced, refer to Service Bulletin.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Immobiliser / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Security Indicator | Theft warning indicator light assembly | ON/OFF | - |
| Tester Display |
|---|
| Security Indicator |
Security indicator light can be turned on and off using the GTS.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the G136 transponder key ECU assembly connector.
Disconnect the H2 theft warning indicator light assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H2-2 (LP) - G136-8 (IND) | Always | Below 1 Ω |
| H2-6 (E) - Body ground | Always | Below 1 Ω |
| H2-2 (LP) - Body ground | Always | 10 kΩ or higher |
| G136-8 (IND) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Connect the G136 transponder key ECU assembly connector.
| *a | Front view of wire harness connector
(to Theft Warning Indicator Light Assembly) |
Measure the voltage and check for pulses according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| H2-2 (LP) - Body ground | Ignition switch off | Pulse generation |
| Ignition switch ON | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>SECURITY INDICATOR LIGHT ASSEMBLY>REMOVAL
NG