Home › Engine / Hybrid System › 1KD-FTV ENGINE MECHANICAL › TIMING BELT
RM33K0E _51 Engine / Hybrid System _043569 1KD-FTV ENGINE MECHANICAL _0225042 TIMING BELT A

1KD-FTV ENGINE MECHANICAL  TIMING BELT  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the timing belt removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of timing belt Mode reset operation
·

Does not illuminate when replacement is necessary

·

Illuminates when replacement is not necessary


(Click here)

PROCEDURE

Hide 51410 1.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 16571C 3.REMOVE NO. 1 RADIATOR HOSE

Hide 16711 4.REMOVE FAN SHROUD

Hide 11322A 5.REMOVE NO. 1 TIMING BELT COVER

a.
A352020

Remove the 6 bolts, 6 washers and No. 1 timing belt cover from the No. 2 timing belt cover and timing gear cover.


Hide 13568 6.REMOVE TIMING BELT

a.
A352021C01
0.667,0.448 1.563,0.448 true 0.677,0.76 1,0.76 1,0.76 1,0.458 true 2.51,0.979 2.677,0.979 2.677,0.979 3.01,1.813 true 3.063,2.75 3.063,2.583 3.063,2.583 3.156,1.844 true 1.583,0.344 1.833,0.51 0.25,0.167 10 false *a 2.333,0.865 2.583,1.031 0.25,0.167 10 false *a 3,2.76 3.25,2.927 0.25,0.167 10 false *a
*a Timing Mark


Turn the crankshaft clockwise and align the timing marks as shown in the illustration.

HINT:

If reusing the timing belt, place matchmarks on the timing belt so that it can be installed exactly as before.



b.
A352022

Uniformly loosen and remove the 2 bolts and No. 1 timing belt tensioner assembly from the timing gear cover.


c.

Remove the timing belt.

HINT:
A352023N01
2.406,0.479 2.802,0.677 0.396,0.198 10 true 90°

·

If turning the camshaft sub-assembly while the timing belt is removed, turn the crankshaft 90° counterclockwise as shown in the illustration.

·

When installing the timing belt, turn the camshaft sub-assembly to align the timing marks, and then turn the crankshaft clockwise to align the timing marks.




Hide 13505 7.REMOVE NO. 1 TIMING BELT IDLER SUB-ASSEMBLY

NOTICE:

When inspecting the No. 1 timing belt idler sub-assembly, do not remove it unless absolutely necessary.


a.

Using a 10 mm hexagon wrench, remove the timing belt idler shaft, No. 1 timing belt idler sub-assembly and timing belt idler spacer from the timing gear cover.