Home › Engine / Hybrid System › 1GD-FTV EMISSION CONTROL › DIFFERENTIAL PRESSURE SENSOR
RM33K0E _51 Engine / Hybrid System _043574 1GD-FTV EMISSION CONTROL _0225245 DIFFERENTIAL PRESSURE SENSOR A

1GD-FTV EMISSION CONTROL  DIFFERENTIAL PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89481B 1.INSTALL DIFFERENTIAL PRESSURE SENSOR

a.
A346701C01
1.74,1.115 2.073,1.281 2.073,1.281 2.24,1.281 true 1.531,1.042 1.052,0.906 1.052,0.906 0.885,0.906 true 2.26,1.167 2.479,1.354 0.219,0.188 10 true *a 0.677,0.792 0.896,0.979 0.219,0.188 10 true *a
*a Paint Mark


Install the 2 air hoses to the differential pressure sensor, and slide the 2 clamps to secure the 2 hoses.

HINT:

Make sure the paint mark of the air hose side the differential pressure sensor.



b.

Connect the 2 air hoses to the No. 1 vacuum pipe and No. 2 vacuum pipe, and slide the 2 clamps to secure the 2 hoses.


c.

Install the differential pressure sensor to the pipe clamp with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


d.

Connect the connector to the differential pressure sensor.


Hide 12601B 2.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY