Home › Engine / Hybrid System › 1GR-FE ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL
RM33K0E _51 Engine / Hybrid System _043519 1GR-FE ENGINE MECHANICAL _0225346 REAR CRANKSHAFT OIL SEAL A

1GR-FE ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear crankshaft oil seal removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Gas leaks from exhaust system Inspection after repair Poor idle, engine start, etc. (Click here)

PROCEDURE

Hide 32101 2.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

A344569N01
1.323,0.563 1.323,0.198 1.323,0.198 2.417,0.198 true 1.729,0.563 1.729,0.208 true 2.448,0.135 2.813,0.323 0.365,0.188 10 true SST

a.

Using SST, hold the crankshaft.

SST
09213-54015  (91651-60855)
09330-00021  


b.
A224777

Remove the 8 bolts, the rear drive plate spacer, the drive plate and ring gear sub-assembly, and the front drive plate spacer.

NOTICE:

Do not reuse the bolts.



Hide 11381A 3.REMOVE REAR CRANKSHAFT OIL SEAL

a.
A326591C02
0.427,0.771 0.625,0.771 0.625,0.771 0.781,1.573 true 2.729,1.51 2.552,1.51 2.552,1.51 1.833,1.052 true 0.25,0.677 0.563,0.833 0.313,0.156 10 false *a 2.771,1.438 3.063,1.688 0.292,0.25 10 true *b
*a Cut Position
*b Protective Tape


Using a knife, cut off the lip of the rear crankshaft oil seal.


b.

Using a screwdriver, pry out the rear crankshaft oil seal.

NOTICE:
·

Be careful not to damage the crankshaft.

·

After removing the rear crankshaft oil seal, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.



HINT:

Tape the screwdriver tip before use.