Home › Engine / Hybrid System › 1GR-FE ENGINE MECHANICAL › CYLINDER HEAD
RM33K0E _51 Engine / Hybrid System _043519 1GR-FE ENGINE MECHANICAL _0225349 CYLINDER HEAD A

1GR-FE ENGINE MECHANICAL  CYLINDER HEAD  DISASSEMBLY  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the cylinder head sub-assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
·

Replacement of cylinder head sub-assembly

·

Replacement of cylinder head LH


Inspection after repair Poor idle, engine start, etc. (Click here)

PROCEDURE

Hide 13751 1.REMOVE VALVE LIFTER

a.

Remove the valve lifter.

HINT:

Arrange the removed parts so that they can be reinstalled in their original locations.



Hide 2.REMOVE VALVE

HINT:

Arrange the removed parts so that they can be reinstalled in their original locations.


a.
A326691N01
2.052,0.323 2.208,0.323 2.208,0.323 2.208,0.677 false 1.792,0.229 2.25,0.427 0.458,0.198 10 false SST

Using SST, compress the inner compression spring and remove the valve spring retainer lock.

SST
09202-70020  (09202-00010)


b.

Remove the valve, inner compression spring and valve spring retainer.


Hide 13734 3.REMOVE VALVE SPRING SEAT

a.
A326692

Using compressed air and a magnet hand, remove the valve spring seat by blowing air.