Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › CLEARANCE SONAR MAIN SWITCH
RM33K0E _56 Audio / Visual / Telematics _043543 PARK ASSIST / MONITORING _0226203 CLEARANCE SONAR MAIN SWITCH G

PARK ASSIST / MONITORING  CLEARANCE SONAR MAIN SWITCH  INSPECTION  


PROCEDURE

Hide 84490A 1.INSPECT BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY

E197682C03
0.729,1.74 0.979,1.74 0.979,1.74 1.25,1.271 true 0.74,2 1.021,2 1.021,2 1.417,1.281 true 1.479,1.99 1.208,1.99 1.208,1.99 1.604,1.271 true 2.406,1.979 2.115,1.979 2.115,1.979 1.802,1.292 true 2.406,1.719 2.188,1.719 2.188,1.719 1.969,1.281 true 0.052,0.021 0.365,0.219 0.313,0.198 10 false *a 0.563,1.646 0.719,1.844 0.156,0.198 10 false E 0.573,1.938 0.948,2.167 0.375,0.229 10 false IG 1.542,1.917 1.896,2.115 0.354,0.198 10 false ILL+ 2.531,1.885 2.885,2.083 0.354,0.198 10 false ILL- 2.49,1.635 2.844,1.833 0.354,0.198 10 false ECU
*a Component without harness connected
(Back Sonar or Clearance Sonar Switch Assembly)


a.

Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
3 (ECU) - 6 (IG) Back sonar or clearance sonar switch assembly off 10 kΩ or higher
Back sonar or clearance sonar switch assembly on Below 1 Ω




b.

Inspect the indicator operation.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 3 (ECU)
Battery negative (-) → Terminal 7 (E)
LED illuminates


If the result is not as specified, replace the back sonar or clearance sonar switch assembly.


c.

Inspect the illumination operation.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 5 (ILL+)
Battery negative (-) → Terminal 4 (ILL-)
LED illuminates


If the result is not as specified, replace the back sonar or clearance sonar switch assembly.