Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE REAR WHEEL
2.REMOVE REAR BRAKE
46430
3.DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
Remove the 2 bolts and disconnect the No. 3 parking brake cable assembly.
89546
4.DISCONNECT REAR SPEED SENSOR LH
Remove the bolt and disconnect the rear speed sensor LH.
5.REMOVE REAR AXLE SHAFT WITH BACKING PLATE
Remove the 4 nuts.
Pull out the rear axle shaft with backing plate from the rear axle housing.
42422B
6.REMOVE REAR AXLE BEARING CASE O-RING LH
Remove the rear axle bearing case O-ring LH from the axle housing.
42312C
7.REMOVE REAR AXLE SHAFT OIL SEAL LH
Using SST, tap out the rear axle shaft oil seal LH.
Be careful not to damage the rear axle housing hole.