Home › Suspension › FRONT SUSPENSION › FRONT STABILIZER BAR
RM33K0E _53 Suspension _043530 FRONT SUSPENSION _0226850 FRONT STABILIZER BAR A

FRONT SUSPENSION  FRONT STABILIZER BAR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front stabilizer bar removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced:
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
w/ Automatic Headlight Beam Level Control System:

The vehicle height changes due to replacement of suspension components or after performing such operations as removal and reinstallation


Headlight leveling ECU assembly initialization Headlight leveling function (Click here)
Front wheel alignment adjustment
·

Clearing zero point calibration data

·

Yaw rate and acceleration sensor zero point calibration


VSC malfunctioning (Click here)


PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 51410 2.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY

Hide 51442 3.REMOVE NO. 2 ENGINE UNDER COVER

Hide 51405D 4.REMOVE ENGINE UNDER BRACE SUB-ASSEMBLY

a.
C322878

Remove the 10 bolts and 2 engine under brace sub-assemblies.


Hide 48810 5.REMOVE FRONT STABILIZER LINK ASSEMBLY LH

a.
C322855

Remove the 2 nuts and front stabilizer link assembly LH.

HINT:

If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud in place.



Hide 48820B 6.REMOVE FRONT STABILIZER LINK ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 48824 7.REMOVE FRONT STABILIZER BRACKET

a.
C322856

Remove the 4 bolts and 2 front stabilizer brackets.


Hide 48815 8.REMOVE FRONT NO. 1 STABILIZER BAR BUSH

a.

Remove the 2 front No. 1 stabilizer bar bushes.


Hide 48811 9.REMOVE FRONT STABILIZER BAR

a.

Remove the front stabilizer bar from the vehicle body.