Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER
RM33K0E _53 Suspension _043531 REAR SUSPENSION _0226852 REAR SHOCK ABSORBER A

REAR SUSPENSION  REAR SHOCK ABSORBER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear shock absorber removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced:
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
The vehicle height changes due to replacement of suspension components or after performing such operations as removal and reinstallation Headlight leveling ECU assembly initialization Headlight leveling function (Click here)


HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 48540 2.REMOVE REAR SHOCK ABSORBER ASSEMBLY LH

a.

Support the axle housing.

i.

Jack up and support the vehicle's frame on stands.


ii.

Lower the axle housing until the coil spring tension is free, and maintain this position.



b.
C334034

Remove the 2 bolts.


c.
C334033

Remove the bolt.


d.

Disconnect the rear shock absorber assembly LH from the axle housing and frame.

HINT:

If it is difficult to remove the rear shock adsorber assembly LH form the axle housing and frame, first compress the rear shock adsorber assembly LH.



e.
C324611C01
2.292,1.875 2.604,2.073 0.313,0.198 10 false *a 0.344,1.677 0.656,1.875 0.313,0.198 10 false *b
*a Turn
*b Hold


Remove the lock nut, 3 rear shock absorber cushion retainers, rear No. 1 shock absorber cushion, rear upper shock absorber bracket LH and rear No. 2 shock absorber cushion.